alproof
drum_eject_overshoot
deo
Trendsetter_400/800_Proofing
The overshoot (in mm) from the trailing edge of the media which we move the drum to while
ejecting the media. Note that this can be a negative offset, meaning that we don't quite move
the drum as far as you'd think we should. The purpose of this adjustment is to ensure that the trailing edge of the media
leaves the drum nice and cleanly, with minimal slack in the unload loop. Too much slack and the media "snaps"
against the drum as it unloads, and too little slack and the media becomes taught as it unloads, which might possibly
stress the receiver which is underneath it.
int8